Safety Instructions; User Manual - Toolland PM3300 Notice D'emploi

1. Introduction
Thank you for choosing Toolland! Please read the manual thoroughly before bringing this device
into service. If the device was damaged in transit, do not install or use it and contact your
dealer. Damage caused by disregard of certain guidelines in this manual is not covered by the
warranty and the dealer will not accept responsibility for any ensuing defects or problems.

2. Safety Instructions

Keep away from children and unauthorised users.
Always wear a suitable dust mask during use.
Always wear protective gloves during use.
Always wear protective eyeglasses during use.
The drill bit and work piece may become extremely hot. Do not touch with bare hands.
Do not use in an explosive atmosphere.
3. General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
 Protect this device from shocks and abuse. Avoid brute force when operating the device.
 Protect the device against extreme heat, dust and moisture.
 Familiarise yourself with the functions of the device before actually using it.
 All modifications of the device are forbidden for safety reasons.
 Only use the device for its intended purpose. Using the device in an unauthorised way will void the
warranty.
 Damage caused by disregard of certain guidelines in this manual is not covered by the warranty
and the dealer will not accept responsibility for any ensuing defects or problems.
 Damage to drills, drill bits, work pieces or any personal injury resulting from the use of this device
is not covered by the warranty.
4. Features
 base with holes for secure bench mounting
 for drills with 38mm or 43mm collar
 adjustable drill depth with rule and stop
5. Overview
Refer to the illustrations on page 2 of this manual.
1 base
2 column
3 stop
4 drill holder
6. Assembly
 Insert the column [2] into the base [1] and tighten it securely with the screw(s) [a].
 Slide the stop [3] over the column.
 Slide the drill holder [4] over the column [2].
 Slide the washer and lever [5] over the bolt and use this to secure the drill holder [4] to the
column [2]. Use the included hex key.
 Lift the lever [5] and the lever support [6]. Align the holes and insert the bolt [e].
Note: the bolt must be inserted at the side of the lever support [6].
 Place a washer over the bolt [e] and tighten the lock nut.
 The drill holder [4] has a provision to store the hex key.
16/10/2015
PM3300

User manual

5 lever
6 lever support
7 preset bolt
8 ruler
3
© Velleman ® nv