Baby Brezza One Step Mode D'emploi page 4

Set-up, Use and Cleaning
Before placing items in the appliance for sterilization it is important that
all bottles, pump parts and accessories must be EMPTY, CLEAN & FULLY
RINSED BEFORE USE in this sterilizer dryer.
1. Place the appliance on a flat surface where it is out of reach of children
and it will not be knocked or moved during operation.
2. Remove the lid, baskets and accessory rack from the sterilizer base.
3. Pour distilled water on the base/heater surface to MAX line (165ml/5.5oz).
Never fill past MAX line.
4. Place the lower basket on the base.
5. Place clean bottles with their opening facing downward on the bottle posts.
6. Place the accessory tray in the lower basket (tray not for use with tall bottles).
7. Place bottle accessories on the accessory rack (nipples, collars, caps, etc).
8. Place the upper basket on top of the lower basket, ensuring that it fits
securely without any gaps.
9. Place breast pump parts or more accessories in the upper basket.
10. Press the power
will turn on. When the sterilization cycle is done, the appliance will
automatically turn off.
Cleaning
- Always unplug your product before cleaning.
- Do not immerse the base, the supply cord or the plug in water or other liquids.
- Do not clean base under water tap.
- Use a soft damp cloth to clean the base and control console.
- Never use abrasive pads to clean the plastic parts of the machine.
- The lid, accessory rack can be cleaned in hot soapy water.
- Mineral residue, particularly in hard water areas, may deposit on the stainless
steel heating plate after a few sterilization cycles. To avoid scale build up,
wipe the surfaces with a soft moist cloth after each operation.
- Deposits can be removed with scale removers or by leaving 60ml/2oz
water and vinegar solution (50/50 water & vinegar mix) on the heating plate
for approximately 30 minutes. The plate should then be wiped clean with
a clean, dry cloth. Some discoloration spots may remain after cleaning with
a vinegar solution, but these are harmless.
- Do not use abrasives or solvents for cleaning; they may damage the appliance
and the surface of the heating plate.
3
button once, the button will light up and the heater