Absaar AB-CP1200 Mode D'emploi page 11

EN OPERATING INSTRUCTIONS
2. Install the polishing disc & the polishing pad.
Before using polisher, please install polishing disc and the polishing pad.
• Place the polishing disc onto the spindle.
• Cover the polishing disc with the the polishing pad
• Srew the hexagon flange tight using the hexagon wrench.
WARNING
load to checking the assembly before operation.
• SPECFICATIONS
Input ........................................................................ 230V~, 50Hz, 1200W
No Load Speed ................................................................500 – 3000 /min.
DOUBLE INSULATED
OPERATION
1. ON/OFF
The switch has a safety button for accoiding accidentally starting and sel-
flock button.
• Open the safety button and depress the power switch to start the tool.
• Press Gown the sell-lock button (on the left side of the power switch) for
continue work.
• If you want to stop the tool, just press the power switch and deliver it
again.
NOTE
in 1-2 sec.
2. To polish cars or furniture with wax:
1) First make sure that the car is not covered with mud or layer of dust before polishing.
2) Oil the polishing pad over the polishing disc, then rest the polishing disc on
the work surface.
3) While the polishing disc is resting on the work surface, grasp the polisher
securely and turn it on. Move the polisher around the car lightly.
– You must let the tool operate for more than 1 minute with no
– The polisher is assembled with a soft start device, so the tool will start
11
AB-CP1200