SE Electronics X1 S Mode D'emploi page 22

sE Electronics RF-X Assembly + Use
Thank you for purchasing an sE Electronics RF-X! We hope it helps make your
tracks sound great - no matter WHERE you're recording.
STEP ONE
The first step is to attach the hardware to
the stand, which is done by screwing the
bracket onto the top of a mic stand, where
the mic or shockmount normally attaches.
*There's an adapter screwed
inside this connector for a
European mic thread size - if
you remove the adapter, the
connector will fit US mic stands.
Use the lever on top of the L bracket
to tighten it, but not too tight, as you'll
probably need to shift it slightly later.
STEP TWO
Next, attach the filter to the vertical portion
of the L bracket by inserting the two included
screws through the vertical cutout in the L
bracket, and into the two screw holes on the
back of the RFX.
RF-X ASSEMBLY MANUAL