Basic Operation - Gardner Bender WIC-100 Manuel D'utilisation

Overview
Battery Installation and Assembly
To Install Batteries
1. Remove battery cover from bottom of camera handle
2. Remove battery compartment and insert four (4) AA (not included) batteries into their appropriate slots,
with proper polarity. Battery compartment has diagrams showing the correct placement of the battery
in each location.
3. Re-install battery cover
To Attach Flexible Camera Tube to Camera Handle
To connect the flexible camera tube with the control handle, first align the keyed tab on the camera tube
connector with the slot on the connector for the camera handle. Slide the connectors together and begin
twisting the threaded collar to secure the camera tube to the handle. FINGER TIGHTEN ONLY!- Do not
tighten with excessive force or tools. Damage to the connectors could result from excessive torque applied
to the threaded collar.
To Install Accessories
The three (3) included accessories (mirror, hook, and magnet) are all attached to the camera in the same way.
• Insert hook in hole
• Slide rubber retaining collar on end of camera tube lens

Basic Operation

1. As you roll the Power/Brightness control wheel to turn the camera on, there should be a click and the
Power LED will illuminate. Once on, the wheel can be turned to increase or decrease the intensity of the
LEDs at the end of the camera tube.
2. When in use, the tube should be able to easily be maneuvered into any necessary position. The flexibility of
the tube allows for bending at most angles to see areas not normally seen by normal visual inspection. DO
NOT USE EXCESSIVE FORCE WHILE ADJUSTING TUBE SHAPE. DO NOT COIL CAMERA TUBE
IN CIRCLE SMALLER THAN A 5" RADIUS. DAMAGE TO THE CAMERA TUBE MAY RESULT FROM
EXCESSIVE FORCE OR TIGHT WINDING.
3. The accessories included with the GB
small objects.
4. The upper section of the camera handle can be rotated. To unlock, press and rotate button in direction
indicated on the camera. To lock handle in current position, turn button in opposite direction. TO AVOID
RISK OF INJURY, DO NOT USE SHARP OBJECTS TO TURN BUTTON. DAMAGE OR HARM COULD
RESULT TO THE CAMERA OR USER.
www.gardnerbender.com | N85 W12545 Westbrook Crossing | 800.624.4320 | tech.support@gardnerbender.com
Wireless Inspection Camera can be used for retrieval of
®