European Union - Southwire 41161N Manuel D'opération

Safety Category Ratings
WARNING:
Operation is limited to CAT II 1000V applications when the insulated tips are removed
from one or both test probes. Refer to Input Limits section of this manual for maximum voltage ratings.
When insulated tip on, the test leads are CAT IV 600V
When insulated tip removed, the test leads are CAT II 1000V
PRODUCT COMPLIANCE
Users of this product are cautioned not to make modifications or changes
that are not approved by Southwire Company, LLC. Doing so may void the
compliance of this product with applicable laws and regulatory require-
ments and may result in the loss of the user's authority to operate the
equipment.
UNITED STATES AND CANADA
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions; (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
5
Product Compliance
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
which the radio or television receiver is connected.
CAUTION: To comply with the limits of the Class B device, pursuant to Part
15 of the FCC Rules, this device is to comply with Class B limits. All
peripherals must be shielded and grounded. Operation with non-certified
peripherals or non-shielded cables is likely to result in interference and
reception of the device.
Canadian Digital Apparatus Compliance
CAN ICES-3(B)/NMB-3(B)

EUROPEAN UNION

In accordance with CE requirements, the Declaration of Conformity may be
found at
www.southwiretools.com.
6