Return Of Ac Power; Ups Shutdown; Using The Ups Remote Control Functions - MGE Pulsar 700 Manuel D'installation Et D'utilisation

Pulsar
End of battery backup time
◗
All the LEDs go OFF.
◗
The audio alarms stops.
The UPS is completely shut down.
3.3

Return of AC Power

Following an outage, the UPS restarts automatically when AC power returns (unless the restart function was disabled via
UPS personalization) and the load is again supplied.
3.4

UPS Shutdown

3.5

Using the UPS Remote Control Functions

Pulsar has the choice of two remote control options.
◗
RPO: Remote Power Off allows a remote contact to be used to disconnect all the equipment connected to the
UPS from the power supply. Restarting the UPS requires manual intervention.
◗
ROO: Remote ON/OFF allows remote action of button (27). These functions are obtained by opening a contact
connected between the appropriate pins of connector (5) on the rear panel of the UPS (see diagram on follow-
ing page).
RT m odel
3 — 2
Press button (27) for approximately 1 second.
The devices connected to the UPS are no longer
supplied.
Tower m odel
Operation
E N G L I S H
86-86700-00 A01