DELTA DORE Tylock Mode D'emploi page 2

Tylock
Bluetooth smart lock
EN
Installation guide
www.deltadore.com
x3
1 European 1 NFC 3 NFC 1 CR2 3V
cylinder card Badges lithium battery
1 Clamping key 1 Fixing screw Installation and
user guide
Technical characteristics
• 1 CR2 3V lithium battery
• Stand-by consumption: < 50 µAh
• Battery life: Up to 2 years
• Compatibility:
Bluetooth: From Bluetooth 4.1
NFC badge: 13.56 MHz mifare classic 1k and Vigik type
• Storage temperature: -20°C/+60°C
• Operating temperature: -20°C/+60°C
• IP 66
• % humidity: 20% ~ 90% without condensation
Download
the Tylock
application
The Tylock lock is only compatible
with the Tylock application
Google play is a registered trademark of Google LLC. App Store is a service
mark of Apple Inc. Bluetooth is a registered trademark of Bluetooth SIG, Inc.
The N mark is a registered trademark of the NFC Forum, Inc.
Remove the button
❶ Unscrew button (B) with the spanner (A).
❷ Remove the insulating tab from the battery.
❸ Test for correct operation of the controller unit (F): Position
the card provided (C) in front of the controller unit (F)
(3 times).
First pass: Unit activates,
Second pass: Unit deactivates,
Third pass: Unit activates.
Remove the controller unit
❹ Use the protruding part on the right side of the spanner (A)
by inserting it into the controller unit housing (F) to push
the mounting clip (D).
❺ Remove the clip (D).
Identify the mounting direction of the clip
(widest part upwards).
❻ Remove the controller unit (F) and then the clamping ring (E).
Install the lock
❼ Insert the cylinder into the door from the indoor side.
❽ Secure the cylinder with the fixing screw (G).
❾ Replace the clamping ring (E), taking care to position the
thread outwards.
❿ Replace the controller block (F) (electronic board on top)
and then insert the mounting clip (D) all the way to the bot-
tom of the slot (make sure the wider part is facing upwards).
⓫ Replace button (B) on the controller unit (F)
paying attention to positioning (foolproofing).
Carefully screw the ring (E) back onto button (B)
using the spanner (A).
In contact with the clamping ring (E),
turn button (B) clockwise by hand until fully tightened.
Your lock is installed.
Download the Tylock application
Depending on your device:
- Scan the QR code opposite to install the application
or connect to Google Play or App Store,
search for and download the free 'Tylock' application.
- Enable the bluetooth connection of your smartphone.
For Android smartphones, enable GPS location.
- Run the Tylock application and follow the instructions.
1
B
A
5
D
4
Indoor
7
G
8
10
UP
F
C
2
x3
3
E
F
6
Outdoor
E
D
9
B
F
11