Configuration - Sophos APX 320X Guide De Démarrage Rapide

ENGLISH
Sophos Firewall
or Router
Sophos Firewall
or Router
Connect the LAN (PoE) port of the access point to a PoE switch or PoE injector using an RJ45
Ethernet cable.
Note: The power supply cord(s) of the PoE injector or PoE Switch must be plugged into socket-
outlet(s) with earthing connection.
The access point will now boot and try to receive an IP address via DHCP (either from the Sophos
firewall or another DHCP server in your network).
After successfully receiving an IP address, the access point attempts to communicate with Sophos
Central. In order to do so, the firewall needs to either be the default gateway of the access point or be
on the default route (most likely your route to the internet).
Whilst waiting for DHCP and searching for the wireless controller, the access point status LED will
show its current state (please see the following table).

3. Configuration

After successful connection to the wireless controller the status LED turns to solid green. The access
point is now ready to be managed.
Please refer to the Sophos Central online help to start the configuration of your access point.
5
PoE Switch
Switch PoE Injector
Quick Start Guide
Access Point
Access Point
APX 320X