Cleaning & Maintenance; Storage & Transportation - Umuzi Cleaning UZ-CL-STIS01 Manuel D'utilisation

During use, the temperature indicator (B) will light up again, indicating it is heating in order to maintain
the set desired temperature.
Note! Always check and observe the label with ironing instructions before you start ironing.
Note! Water may drip while spraying steam, when the temperature is lower than the set temperature. This
is normal.
Warning! Do not pull the steam trigger when the device is placed on the thermal isolation.
Once you have finished ironing, unplug the power plug from the electrical outlet, so the device is
switched off and able to cool down.
The soleplate will still be hot, never touch it, otherwise you run the risk of burning yourself.
4) CLEANING - MAINTENANCE
Before cleaning the device, always disconnect it from the mains electricity supply and allow it to
cool down fully.
Cleaning
• Turn the temperature dial (D) to the minimum (I).
• Drain the remaining water from the water tank (1) and clean the tank after each use.
• Never use aggressive or abrasive cleaning materials or sharp objects like hard brushes or knives.
• Wipe residues and any other deposits off the soleplate (A) using a damp cloth or a non-abrasive (liquid)
cleaner.
• Do not use chemical, steel, wooden or abrasive cleaners to scrape the soleplate (A).
• Clean the exterior of the casing with a damp cloth.
• Then dry the exterior with a dry cloth.
• Place the power cord & steam supply hose in the cord clips (4).
5) SPECIFICATIONS
• Voltage input: 220-240 V~, 50-60 Hz, Class I
• Power: 2000-2400 W
• Tank capacity: 1.2 L
• Dimensions: 28 x 21 x 34,5 cm (H x W x D)
• Weight: 2.3 Kg.
6) STORAGE & TRANSPORTATION
• When storing the device, it should first be cleaned in accordance with this user manual. The device
should be stored in its original packaging.
• Always store the device in a dry and well-ventilated room and beyond the reach of children.
• Protect the device against vibrations and shocks during transport.
All contents and specifications mentioned in this manual are subject to change without prior notice.
EN-8