Heath Zenith 7560 Mode D'emploi page 6

WIRELESS CHIME INSTALLATION
IMPORTANT: When using this chime with a transformer, bat-
teries are not needed and should not be installed even when
using wireless push buttons.
This chime requires 3 "C" alkaline batteries (not included).
In typical use, alkaline batteries will last up to one year.
WARNING: To prevent possible SERIOUS INJURY
or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
1. If chime is not connected to transformer wires then install 3
alkaline "C" batteries. Make sure batteries are oriented properly
(see Figure 4).
2. Remove back of push button by pushing in tab on bottom with
a small screwdriver (see Figure 5).
3. Look inside the push button and determine which type of push
button will be connected to the chime (see Figure 6).
• Push Button 3A (2 Switches): The push button has only two
switches. Go to step 4.
• Push Button 3B (1 Jumper): The push button has a single
jumper. Go to step 5.
• Push Button 3C (7 or 8 Jumpers or Switches): The push
button has a row of 7 or 8 jumpers or switches. Go to step 5.
-6-
SYNC – PRESS
AND RELEASE.
RESET – HOLD
10 SECONDS.
TUNE – HOLD
FRONT TRANS REAR
1 SECOND.
Figure 4
Figure 5
Continued
3A
ON
TYPE "C"
1 2
3B
TYPE "C"
ON
1 2 3 4 5 6 7 8
1 2
3C
ON
1 2
Figure 6
207702-02