Publicité
Les langues disponibles
Les langues disponibles
Step 1
Fig. 1
Remove the transmitter battery tray
by sliding the bottom cover. Install
eight (8) AA alkaline batteries into
the battery holder . Pay close attention
to the correct direction of the positive
(+) and negative (-) ends as marked in
the tra y. Reinstall the battery tray using
the molded pegs in the bottom as a
guide for the correct location and
replace the bottom cove r.
Step 4
Remove the battery box top by lightly
prying the bottom rail of either end of
the retaining clip. Install four (4) AA
alkaline batteries into the battery box,
again paying close attention to the
correct direction of the cells. Replace
the cover and make sure the retaining
clips snap over the railsat either end.
Fig. 7
After you are done running, turn the Mini-T off FIRST by sliding the switch toward the back of the truck (Fig.5). After the model has been
turned off, turn of f the transmitter (Fig. 6). If you wish to clean your Mini-T, use compressed air and/or a soft paintbrush to remove dust and
dirt. NEVER use chemicals or anything wet as it can cause damage to both the electronics and plastic parts.
AL WA YS
Turn on the transmitter before the truck
Use caution when running around peope
Turn both the Mini-T and transmitter "off" when done
Check the battery condition of the transmitter before running
www.teamlosi.com
Before you start running your new Mini-T ,it is absolutely necessary that you read through all of the
operating instructions to get the maximum enjoyment and prevent unnecessary damage.
Step 2
After removing the body, remove
the small hatch pin just in front of
the the receiver above the steering
servo. Carefully swing the plate
with the receiver/speed control
upward and remove the battery box.
Step 5
Fig. 4
Intstall the battery box with the
plug at the right front corner. Let
the receiver/speed control plate
drop over the batteries onto the
mounting post and replace the
hatch pin that secures it in place.
Plug in the battery using the slots
and bars molded into the plugs as
a guide and your are ready to go!
Fig. 2
Fig. 5
Step 7
Tu rn on the Mini-T by sliding the switch on the right side of the
receiver forward (Fig 5.) as noted on the side of the switch. If
the rear wheels turn, adjust the "TH.TRIM" knob (Fig.8) located
to the lower right of the steering wheel until they stop. To go
forward pull the trigger back. If you should need reverse, wait
for the model to stop then push the trigger forward. When going
forward the model should move in a straight line. If not, adjust
the "ST.TRIM" (Fig.8) so that it tracks in a straight line without
Fig. 8
having to turn the steering wheel.
NEVER
Operate the Mini-T with low battery power
Run the Mini-T through water or wet grass
Use chemicals to clean the chassis
Run the Mini-T without a gear cover
Step 3
Fig. 3
Insert the antenna wire through the
antenna mount and into the antenna
tube pushing it through until it comes
out the other end. Push the antenna
tube into the antenna mount.
Step 6
Always turn on the transmitter first by
sliding the switch on the left side upward.
The small red and green lights to the left
of the steering wheel should both light up.
If not you need to checkfor low or in -
correctly installed batteries.
www.graupner.de
Fig. 6
Publicité
