Navistar TBM3-N2 Manuel D'utilisation page 9

Below are the steps to connect the harness connectors to the Navistar N2 Telematics module:
1. Identify 4 connector (8-pin connector) on the module (See Figure 4.1.1)
2. Identify the Communication and Power Connector on the truck's harness (see Figure 4. 1.2), this harness
provides access to CAN 1, CAN 2 & J1708 communication channels
3. Assemble the Truck's Harness Communication Connector to the module's 4 connector
4. Identify connector 5 (20-pin connector) on the module (See Figure 4.1.1)
5. Identify the Interface Connector in the truck's harness (see Figure 4. 1.3)
6. Assemble the Interface Connector in the truck's harness to the module's 5 connector
7. Once the module has been assembled, the module is able to operate for a12V or 24 V system with the
operating range specified in the Electrical Requirements Section
Public
Review F
This document is not included in the product packaging