Hema 80.06.0022 Mode D'emploi page 20

PARTS DESCRIPTION
1. Clamping ring
2. Front guard
3. Blade fastening screw
4. Fan blade
5. Guard fastening screw
6. Rear guard
7. Motor shaft
8. Shaft pin
9. Oscillation knob
10. Speed control buttons
11. Standing shaft
12. Standing base
13. Power cord and plug
ASSEMBLING INSTRUCTIONS
1. Base Assembly
Put power cord (13) through the hole of standing base (12). Align the bottom of standing shaft (11) with the
hole of standing base, turning to fix the connection. Set the power cord through the groove at the edge of
standing base.
2. The Whole Assembly
Remove the blade fastening screw (3) and guard fastening screw (5) from the motor shaft (7) spindle.

Fit the rear guard (6) by positioning with the location pins. Secure the guard onto the motor body with the

guard fastening screw (5).
Place the fan blade (4) onto the motor shaft by matching the slot with the shaft pin (8). Fix the blade by

tightening the blade fastening screw (3) in a counter-clockwise direction. Check that the fan blade can
rotate freely by turning it with your hand.
Put the front guard (2) against the rear guard (6) and fix with the clamping ring (1). Make sure the

clamping ring is set properly at the rim of the fan guards. Tighten the screw on the clamping ring.
OPERATING INSTRUCTIONS
1. Plug the power cord into a suitable socket.
2. Oscillation: To make the fan head oscillate, push down the oscillation knob (9). To stop the fan head from
oscillating, pull up the oscillation knob.
3. The fan is switched on and off by pressing the speed control buttons, i.e. 0 = Off, 1 = Low air flow speed, 2
= Medium air flow speed, 3 = High air flow speed.
4. Tilting Angles: By pushing the fan-guard, you can adjust the fan to the preferred elevation.
CAUTION:

Press only one of the speed control buttons at a time. Permanent damage to the switch housing may
result if two or more of the buttons are pressed simultaneously.
CLEANING
1. Before servicing the fan and after each occasion of use, switch off the appliance and unplug the mains
cable from the socket.
2. Never immerse the appliance in water (danger of short-circuit). To clean the appliance, only wipe it
down with a damp cloth and dry it carefully. Always take out the mains plug first.
3. Take care that excessive dust does not build up in the air-intake and air-outlet grille, and clean it
occasionally using a dry brush or vacuum cleaner.
- 19 - 80.06.0022