Peaq PMS200BT-B Mode D'emploi page 37

Setup
Select a stable, level and clean surface to
place the product. Route cables so that they
do not become a trip hazard and do not
place heavy or sharp objects on the cables
or units. Leave about 10 cm for ventilation
around the product.
AUDIO INPUT
Connect the playback device with the RCA
cable (red/white) to the AUX input.
NOTE: RCA cable is not included.
SPEAKER CONNECTION
R
Unwind speaker cables and connect the
cables to the main unit. Make sure by ob-
serving the correct polarity on the terminals
(black is / white is ).
PMS200BT_A5_131031_1.indb 37
Operation
POWER SUPPLY
Connect the power plug to a suitable power
outlet.
POWER ON/OFF
Press the power switch on the rear of the
main unit to the ON position. Press
L
remote control or on the touch panel to turn
on the product.
INSERTING BATTERY
1. Open the battery compartment cover.
2. Insert the new batteries into the battery
compartment while paying attention to
the correct polarity.
3. Close the battery compartment cover.
ENGLISH
on the
37
31/10/13 2:54 PM