Battery Recharging; Function Descriptions; Usb Mode - Vava VA-CD007 Guide D'utilisation

1) Turn off the car engine.
2) Insert the micro SD card into the micro SD card slot.
3) Slide the DVR into the suction cup mount. Position at your best viewing angle.
4) Install the USB cable (for installation) properly to prevent your view from being blocked.
5) Connect the DVR to the car charger through the USB cable (for installation).
6) Adjust the DVR to keep the lens level with the ground.
7) Start the car engine to check if the DVR is working properly.

2. Battery Recharging

1) Recharge via car power or USB power adapter.
2) Please charge for at least one hour before use.
3. Auto Start / Stop
1) To automatically start recording upon ignition, you must:
a) always connect the device to car power;
b) enable Loop Recording function (turned on by default).
2) When you turn off car ignition, the device will continue recording for 15 seconds and automatically
save the footage and then shut down.

Function Descriptions

1. Instant Mute
When recording, press <▲> to mute the Mic. Press again to resume.
2. SOS
While recording, press< >to lock the video and protect it from being overwritten during Loop Recording.
!
3. Auto Power Off
When powered by its battery alone, the DVR will automatically power off after 30 seconds (default) if
not recording and there is no operation.
4. Loop Recording
If turned on, new recordings will overwrite the oldest video footage when the micro SD card becomes
full. If turned off, the device will stop recording when the micro SD card is full. Loop cycle can be set
to 1 (default) / 3 / 5 minutes.
5. LCD Display Off
Set display to Normally On (default) or automatically turn off after 1 / 3 / 5 minutes when there is no
operation.
6. Driving Time Reminder
Set driving time reminder to Off / 1 / 2 / 4 (default) hours.
7. Parking Mode (turned off by default)
Wake up device for emergency recording if an impact or collision is detected. Device will automati-
cally shut down when emergency recording completes.
8. G-Sensor
If any impact or collision is detected during recording, a 'Lock' sign will appear on the left top corner
of the screen. Locked videos will not be overwritten in LOOP RECORDING.
Note: G-Sensor sensitivity can be set to Off / High / Medium (default) / Low.
9. Auto Video Restoration
Automatically restore damaged videos caused by low battery power or malfunction when the unit
next starts.

10. USB Mode

Enter USB Mass Storage Mode when connected to PC. Go to folder EVENT for locked videos. Go to
03/04