Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Instruction Manual
Straight Cutting Board to Size
1.
Remove mat guide and slip sheet.
Set measuring bar stop to dimension of cut (Fig. 6).
2.
3.
Place mat color side down under guide rail and against squaring bar stop.
4.
Set the proper depth setting on the Straight Cutting Head.
5.
Hook the Straight Cutting Head onto the Guide rail past the end of the board to be cut.
Grasp the handle as shown in the picture, pivot down and pull the Straight Cutting Head
towards you. Keep constant downward pressure on the Straight Cutting Head and the
Guide Rail as you make your cut (Fig. 7).
CAUTION: Be careful to control the Straight Cutting Head as it breaks through
the end of the matboard, as it will tend to "jump" towards you.
Note: Matboard wider than 32" (81cm) will not fit between the hinges and must be cut by
some other means such as Model 500 mat knife or utility knife with a T-square.
Bevel Cutting Mat Openings, Without Rail Stops
EXAMPLE: Cutting a mat with a 2" border.
1.
To re-install the Mat Guide, loosen the Black Knobs with the raised edge towards the
Guide Rail, line up the Mat Guide with the parallel slots. Hold the Mat Guide at either end
and evenly drop the Mat Guide into the slots and then tighten the black knobs.
2.
Set the Mat Guide to the desired border width. For example, for a 2" border, align the
back of the Mat Guide at the 2" mark and tighten the Black Knobs (Fig. 8).
3.
Make sure the Slip Sheet is in place before bevel cutting. You must use a Slip Sheet. The
straight cut slot underneath the Guide Rail is for straight cutting only.
4.
Place the mat color side down under the Guide Rail and up against the squaring bar and mat
guide (Fig. 9).
5.
Using a pencil, draw a line down the full length of the back of the matboard. Turn the
mat after each marking and repeat this for the remaining three sides (Fig. 10).
6.
Attach the 302 Bevel Cutter to the Guide Rail by fitting the black nylon guides over the
raised edge of the channel.
7.
Position the cutter so the middle start & stop line lines up with the marked line closest to
the bottom of the machine (Fig. 11).
NOTE: Extra start & stop lines are for reference to increase or decrease overcuts.
Fig. 9
Slip Sheet
Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 847-526-5515 www.logangraphic.com
Compact Elite Mat Cutter
Fig. 10
Model 350-1
Fig. 6
Fig. 7
Fig. 8
2"
5.08cm
Fig. 11
Mat Guide
4
Publicité
Table des Matières
