Coxreels SLP Série Manuel D'installation Et D'entretien page 3

INSTALLATION AND MAINTENANCE MANUAL
MOUNTING OF REEL
•
Review mounting configuration for floor, ceiling, or wall mount. Standard configuration is floor mount (see Fig. 1.0). Refer to Fig. 2.0 for optional ceiling mount
or Fig 3.0 for wall mount positions.
•
Mount reel to a solid structure using six 7/16" or M12 bolts, washers, and nuts. Six masonry bolts may be used depending on mounting application. Mounting
hardware is NOT provided. The mounting base of the reel has six ½" holes.
•
Fit reel. Install hardware in reel base. Securely fasten all bolts and nuts.
•
Overhead or Wall installation mountings should be such that the reel is not solely supported by bolts in tension. A safety chain, cable, enclosure or netting is
strongly recommended to minimize damage and/or possible injury in the event of a mounting failure.
Standard "FM" Position
FIGURE 1.0
INSTALLATION OF INLET HOSE
•
Apply thread sealant to inlet hose and connect to the swivel joint on
reel.
CAUTION: IT IS IMPORTANT TO USE A "FLEXIBLE" INLET
HOSE. DO NOT USE SOLID PIPING OR RESTRAIN INLET HOSE
AS TO CAUSE ANY SIDE FORCE ON SWIVEL JOINT. THE
WARRANTY IS VOID IF NOT PROPERLY INSTALLED.
•
Flush some product through the system before connecting inlet hose
to the source.
•
Install inlet hose into swivel assembly by hand tightening, followed
by ½ turn with wrench. DO NOT over tighten as it may damage
swivel.
•
If reel includes hose (Otherwise, See Installation of Hose), flush
some product through system before connecting end fitting, nozzle,
or tool.
•
(Reel supplied less hose) Apply thread sealant to outlet hose fitting.
Connect end, nozzle, or tool as desired.
•
If a hose stopper adjustment is required to allow easy reach of end
fitting or tool; latch reel at approximate desired location, loosen (two)
ball stop bolts. Move ball stop and tighten bolts. Unlatch reel.
•
Connect Inlet hose to supply source.
INSTALLATION OF OUTLET HOSE
FIGURE 4.0
For assembly drawings, parts lists, or specific repair instructions, refer to web site at
Coxreels, Inc., 5865 S. Ash Ave., Tempe, Arizona, USA, 85283
CM Position
FIGURE 2.0
NOTE: Before proceeding, ensure that you are installing the proper size, length
and type of hose per the reel rating. Consult factory if unsure of rating. Damage
may occur if wrong hose is installed.
•
Securely stabilize the reel.
•
Wind the reel drum counter-clockwise (facing the swivel) until the
spring is tight.
Use Extreme Caution!
•
Back off approximately two turns and lock the reel drum to keep from
rotating.
•
Insert the MALE fitted end of the hose through the roller guide and
up to the outlet riser. See Fig. 4.0
•
Apply thread sealant; connect hose fitting to the outlet riser.
•
CAREFULLY release the locking ratchet and SLOWLY allow the
hose to retract onto the reel.
NOTE: See "Spring Tension Adjustment" procedure for proper tensioning of
reel.
CAUTION: Fully extend and charge hose before winding on to reel. Briefly open
control valve to purge hose of gases. When fluid appears at control valve, close
valve. This prevents flattening of the hose and excessive pressure on the drum
when fluid supply is reinitialized at a later time.
Page 3 of 4
www.coxreels.com
Tel: 1-800-269-7335
FORM #PM-002 REV C 09/13
WM Position
FIGURE 3.0
or consult factory.