USE & OPERATION
CONTROL PaNeL
(2)
(4)
Model with Heat Mode
1) Timer Control /Sleep Control
4) Mode Control
FUNCTION BUTTONS
POWER CONTROL
The Power Control
the POWER indicator light will illuminate red indicating the unit is in a Standby Mode, ready to be switched on
at anytime. The air vent will automatically open when the unit is turned ON and automatically close when unit is
turned OFF.
TIMER CONTROL
The Timer is adjustable between 1 - 24 hours.
AUTO TURN Off:
While unit is running, press the TIMER button
press the + or - button to select the number of hours you want the unit to turn OFF automatically.
AUTO TURN ON:
When unit is in a standby mode (plugged in with power light on), press the TIMER button
will flash. While the display is flashing, press the + or - button to select the number of hours until you want the
unit to turn ON automatically.
TEMPERATURE CONTROL
•
Used for adjusting the timer and thermostat.
•
The default display is setting temperature.
•
In cooling mode, when + or - button is pressed, the set temperature is displayed and may be adjusted.
Note: By pressing both + / - buttons at the same time, the display will toggle between Celsius(°C)
and Fahrenheit(°F).
WATER fULL LIGHT
Condensation may accumulate in the unit.
If the bottom internal tank is full, the WATER FULL light
seconds. The unit will not operate until the water has been drained from the bottom drain plug (refer to Water
Condensation Drainage).
After switching the Quilo
You must wait about 4 minutes before it switches back on again.
(3)
(1)
(6)
(5)
C
o
o
F
2) Fan Speed Control
5) Power Control
turns the unit on and off. When the unit is plugged into an appropriate electrical outlet,
TM
Portable Air Conditioner off, the compressor will not start immediately.
(2)
Model without Heat Mode
3) Timer / Temperature Set Controls
6) Warning Light
and the display will flash. While the display is flashing,
will illuminate and an alarm will beep for 30
EN
6
(4)
(3)
(1)
(6)
C
o
o
F
and the display
(5)
EN