Publicité
Les langues disponibles
Les langues disponibles
SUPPLEMENT
RGB-LED Controller
Item no. 18 18 18
Information on using an IR remote control
To increase the number of compatible remote controls, the RGB-LED controller supports
additional device codes as of version 1.3.
We recommend the following IR remote controls for operation:
„OneForAll URC 2981", item no. 943361: Device code 0081 = Philips VCR
„OneForAll URC 3920/3940", item no. 942168/942169: Device code 20081 = Philips VCR
„Vivanco UR2300", item no. 396725: Device code 0411 = Philips VCR
Programme them with the indicated device code according to the enclosed operating
instructions.
As an alternative, we recommend the pre-configured remote control with item no. 994493
(„Philips SRP4004/86") in mode „VCR".
1
4
5
7
6
2
3
„OneForAll URC 2981"
Item no. 943361
Device code 0081 = Philips VCR
www.conrad.com
Version 04/13
1
2
3
5
4
7
6
„OneForAll URC 3920/3940"
Item no. 942168/942169
Device code 20081 = Philips VCR
1: ON/OFF
Switch on the control device. The programme set with the jumpers is started. It is executed with
the speed pre-selected by potentiometer and at full brightness. Repeated operation switches
off the device again.
2: Programme selection buttons „1" to „9"
Selection and start of the respective colour sequence; start with basic speed and full brightness
3: Buttons „AV" and „-/--"
Relevant for setting own colours. „AV" leads to increase, „-/--" to reduction of the respective
colour share when setting own colours, see item 7, bottom.
4: „Volume down"/„Volume up" (or control cross left/right)
Brightness of the programme played up/down
5: „Ch+"/„Ch-" (or control cross up/down)
Start of the next or last programme with basic speed and full brightness
6: Forward/reverse/pause/start
Accelerate / decelerate / pause / resume programme
7: Red/green/blue buttons
Mix colour:
Pushing button „AV" briefly first: Colour ratio is increased.
Pushing button „-/--" briefly first: Colour ratio is decreased.
A running programme is terminated.
1
4
5
7
2
3
6
„Vivanco UR2300"
Item no. 396725
Device code 0411 = Philips VCR
This information was published by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
(www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming,
or the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in
technology and equipment reserved.
© Copyright 2013 by Conrad Electronic SE.
1
3
7
5
4
6
2
3
„Philips SRP4004/86"
Item no. 994493
Mode „VCR"
Publicité
