Display - SamplexPower SSW-R1-12B Guide D'utilisation

seCtIOn 3 |
• P ress ON/OFF Button (1 in Fig 2.1) to Switch OFF the Inverter: The LCD
Display (2 in Fig 2.1) will switch OFF. However, the Inverter will not switch
off and the batteries will continue to drain due to the following energy
consumption:
(i) D ue to the "no load draw" of the inverter if no load is present or due
to the DC side current draw if AC load is present
(ii) D ue to the power drawn by the fans (the fans in the Inverter run
continuously as long as the inverter is in ON condition)
2. LCD display
3. (Not shown. Located at the back of the Remote). 8P8C (8 Position, 8 Conductor)
Modular Connector Receptacle (also known as RJ-45 Receptacle) used for
connecting the Remote Control to the Inverter with the help of 10', Cat 5, 8
conductor cable.

3.1 DiSpLAY

A Green backlit LCD display is used to display operational parameters and fault
conditions. Details of information displayed are shown at fig 3.1 below:
4
fig. 3.1 Details of LCD Screen
Display
The backlighting has 2 intensities
of brightness – dim and bright:
• W hen the inverter is supplying
no power (is in no load condi-
1
tion) or lower power below the
3
minimum power display thresh-
2 old of 50W to 100W, the bar
graph will NOT be displayed.
Also, the back-light will be dim
• W hen the power supplied
is more than the minimum
power display threshold of
50W to 100W, the 1st bar will
appear and the back-light will
brighten. More number of bars
will be displayed proportional
to power output level.
SAMLEX AMERICA INC. | 5