Items Supplied; Proper Use - EINHELL BTS 400 Mode D'emploi

Anleitung BTS 400-150-1
1. Layout
1. On/Off switch
2. Rubber feet
3. Thumb screw
4. Angle scale
5. Base
6. Sanding/grinding section
7. Cross stop
8. Leg support
9. Sanding/grinding belt clamp
10. Knurled screw for sanding/grinding belt
adjustment
11. Sanding/grinding belt
12. Stop rail
13. Sanding/grinding disk
14. Sanding/grinding table
15. Lock screw for sanding/grinding table
16. Plastic guard

2. Items supplied

Belt and disk sander/grinder
Sanding/grinding disk
Adhesive sanding/grinding disks
Sanding/grinding belt
Socket-wrench

3. Proper use

The belt and disk sander/grinder is designed for
sanding/grinding all types of timber, commensurate
with the size of the machine.
The machine is to be used only for its prescribed
purpose.
Any use other than that mentioned is considered to
be a case of misuse. The user/operator and not the
manufacturer shall be liable for any damage or injury
resulting such cases of misuse.
The machine is to be operated only with suitable
sanding/grinding belts which comply with the
specifications contained in these operating
instructions.
To use the machine properly you must also observe
the safety regulations, the assembly instructions and
the operating instructions to be found in this manual.
All persons who use and service the machine have
to be acquainted with this manual and must be
informed about its potential hazards.
It is also imperative to observe the accident
prevention regulations in force in your area.
The same applies for the general rules of
occupational health and safety.
The manufacturer shall not be liable for any changes
made to the machine nor for any damage resulting
from such changes.
30.08.2005 9:27 Uhr Seite 9
Even when the machine is used as prescribed it is
still impossible to eliminate certain residual risk
factors. The following hazards may arise in
connection with the machine's construction and
design:
Harmful emissions of wood dust when the
machine is used in closed rooms.
For functional reasons the rotating parts in the
device cannot be covered. It is therefore
imperative that you proceed with caution and
hold the workpiece firmly to prevent slippage, as
this may result in your hands coming into contact
with the sanding/grinding belt.
4. Important notes
Please read this manual carefully and pay attention
to the information provided. Use this manual to
familiarize yourself with the machine, its correct use
and safety regulations.
Safety regulations
Caution! When using electric tools it is
imperative to take the following basic safety
precautions in order to reduce the risk of electric
shock, injury and fire. Read and take note of
these instructions before you use this tool.
Follow all these safety regulations before and
while working with the belt and disk
sander/grinder.
Do not lose these safety regulations.
When working outdoors, use only extension
cables that are approved for outdoor use and
which are marked accordingly.
Concentrate on what you are doing. Take a
sensible attitude to your work. Never use the tool
when you are tired.
Never use a tool with a switch that cannot be
turned on and off.
Caution! The use of plug-in tools and
accessories other than those intended may put
you at risk of injury.
Always pull the plug out of the power socket
before adjusting or servicing the machine.
Give these safety regulations to all persons who
work on the machine.
Never use tools or attachments with insufficient
power for the job in hand.
Never use tools on jobs for which they were not
intended!
Make sure you stand squarely and keep your
balance at all times.
Check the tool for possible damage!
GB
9