Problems And Solutions - D Light 360 Manuel De L'utilisateur

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

HOW TO PERFORM A PATCH TEST

Because the skin tone varies from area to another, you should perform a patch test to each

body area to be treated. First check your skin tone comparing it with the skin color chart on the

instruction manual and packaging.

Identify a small area to be treated.

Shave the area to be treated.

After having set to the lowest level, apply the handpiece to the area and emit the first pulse.

If you do not feel any kind of discomfort, increase the energy to the next level, move the

handpiece to the adjacent part of skin and emit a new flash.

Increase the energy level on every part of the next skin until reaching the highest level (but it must

remain bearable depending on skin type). During treatment it is possible (and normal) to feel a

warm sensation on the skin. If there is a feeling of discomfort, it means that the highest energy

level endured the previous one.

After 24 hours check the area: the persistence of redness indicates that the skin tolerated

the highest energy level on the previous one. Although it is extremely rare, if hypersensitivity

persists for more than 24 hours, it is advisable to consult a physician.

CAUTION: The energy directly delivered affects the result, but because of the principle

treatment, you should not exceed the maximum threshold that your skin is able to tolerate. This

threshold is normally high for light skins and low for dark skins, because the presence of melanin

darkens the skin, increases heat production. Do not exceed the highest threshold that your skin

can tolerate without any kind of discomfort.

MAINTANANCE

CLEANING AND CONSERVATION

It is recommended that you clean the Flash window after each epilation session:

Switch off the appliance by holding the ignition button down (9) and disconnect the Power plug

(6)

Gently wipe the flash window of the device (11) with a clean dry cloth. For proper cleaning of

the flash area, it is highly recommended to use Kera Flux detergent

Store the appliance in a cool dry place, away from heat and water sources.

When the light is empty, the counter reaches zero.

NOTE:

If large stains appear inside the treatment surface (11) or if the latter is cracked or broken, do not

use the appliance and contact the D Light Service center. After replacing the lamp, always set the

energy level to lower than the one used normally. In the next session, increase the energy level

again only if the there is no abnormal discomfort during or after treatment.

Never immerse the appliance or any of its parts in water!