CTC CLATRONIC HSM-R 2592 Mode D'emploi & Garantie page 30

40986-05-HSM-R 2592
GB
Components
1. Cutting head
2. ON selector
3. Cutting length comb:
4, 6, 8, 10, 12, 14, 16 mm
4. Charging LED
Accessories:
Direct connection mode and battery mode
The hair and beard cutting machine can be used either in direct connection mode
with the adapter or in battery mode after being charged. For DIRECT CONNEC-
TION MODE insert the plug of the adapter into a 230V/50Hz socket, insert the
connection cable into the connection socket located on the hair clipper and place
the function selector either on ON. The machine is pre-charged ex works. Please
charge up the device for 12 hours before initial use. The maximum length of the
subsequent charge cycles is approximately 8 hours. When fully charged the device
has a maximum operating life of 25 minutes. After this time it must be switched off
and allowed to cool down for 25 minutes. The charging LED lights up during the
charging procedure.
Useful tips on battery life
Battery life can be lengthened by paying attention to the following instructions:
• Wait until the battery is almost completely flat before charging it.
• Never leave the machine connected to the charger for more than 24 hours.
• Charge the machine only with room temperatures between 0 and +40°C.
Beard trimming and cutting
• Shift the selector (2) to the ON position. Start with the longest cutting level and
shorten the whole beard or the beard on the chin or cheeks gradually to the
desired length.
Note: Lock the selected cutting length (cutting length comb) in position with the
locking switch located on the back of the housing (position 8 – „lock").
Hair cutting/thinning
• Shift the selector (2) to the ON position. Start with the longest cutting level and
shorten the hair gradually to the desired length.
Note: Lock the selected cutting length (cutting length comb) in position with the
locking switch located on the back of the housing (position 8 – „lock").
30
29.08.2002 12:46 Uhr
Use
5. Connection socket
6. Adapter (charger)
7. Charging station/mounting
8. Locking switch
(Lock/Unlock)
1. Comb
2. Cleaning brush
3. Special oil
Seite 30