Codes D'erreurs - BUVA EcoStream VMC Manuel Technique

BUVA homecare systemen | BUVA EcoStream VMC

Codes d'erreurs

Les messages d'erreur seront visibles sur la page d'état de l'application EcoStream. Vous trouverez ci-dessous une liste des messages
d'erreur signalés à l'application
0x01010000 ERROR_COMM
0x01020000 ERROR_COMM
0x02010000 ERROR_SETTINGS
0x02020000 ERROR_SETTINGS
0x02030000 ERROR_SETTINGS
0x02040000 ERROR_SETTINGS
0x0302XXXX ERROR_SENSOR
0x0303XXXX ERROR_SENSOR
0x0305XXXX ERROR_SENSOR
0x0306XXXX ERROR_SENSOR
0x0401XXXX ERROR_FANS
0x06010000 ERROR_HEATER
0x07010000 ERROR_BYPASS
0x08000000 ERROR_FILTER
0x090XXXXX ERROR_SYSTEM
1 WIFI_CONNECT_FAIL
2 WIFI_TIME_SYNC_FAIL
1 GETPARAM_NOT_FOUND
2 SETPARAM_NOT_FOUND
3 VALUE_INVALID
4 ACCESS_DENIED
2 NOT_CONNECTED
3 INIT_FAILURE
5 OUT_OF_RANGE
6 READ_FAILURE
1 FAN_STALL
1 HEATER_FAULT
1 BYPASS_FAULT
0 REPLACE_FILTER
0 * Failed to connect to WiFi Network
0 * Failed to get time from time server
0 * Parameter not found during get
0 * Parameter not found during set
0 * Parameter value invalid
0 * Attempting to write to read-only parameter
SENSOR_ID * Analog Temperature Sensor out of range (<-39°C)
* HDC1010 RH sensor not detected
* CCS811 VOC sensor not detected
SENSOR_ID *Failed to configure HDC1010 RH sensor
*Failed to configure CCS811 VOC sensor
SENSOR_ID * Analog Temperature Sensor out of range (> 100°C)
SENSOR_ID *Error while reading from HDC1010 RH sensor
*Error while reading from CCS811 VOC sensor
FAN_ID * Fan has stalled
0 * Heater Fault
0 * Bypass Fault
0 * Replace Filter Warning
*Return to manufacturer / replace PCBA
27