Lubrication - Porter Cable PCC795 Manuel D'instructions

3. Clean the filter by shaking off excess dust, tapping into
a waste receptacle, then rinsing under running water.
Depending on the condition of the filter, a water wash is
not always required. Do not use a brush to clean filter.
4. Reinstall filter and secure the filter lock onto power
head. Twist the filter lock clockwise and ensure the filter
is locked in place.
5. Replace power head onto the tank and secure latches.
nOTE: Please contact your local service center or go to
https://servicenet.portercable.com to purchase a filter.
Fig. F
18
Blower
The blower function can be used to remove debris from
behind small spaces, to dry a damp floor, to blow grass
clippings or leaves from an outside walk, patio, etc.
TO USE AS A BLOWER (Fig. G)
1. Empty the tank following the instructions under the
Vacuum Cleaning section of this manual.
2. Twist the vacuum hose
from the intake port.
3. Align the hose end
13
ensuring the hose alignment lock
arrow above the side exhuast port.
15
4. Insert the hose end into the side exhaust port and twist
clockwise to lock in place.
Fig. G
15
Hose and Accessory Storage
When the vacuum is not in use, remove the battery pack.
The vacuum hose can be wrapped around appliance,
underneath the battery interface, and secured with the
hose clip 7 also located at the back of the vacuum. The two
accessories (crevice tool and wide nozzle) can be stored on
board the vacuum as well.
MAINTENANCE

WARNING:
serious personal injury, turn unit off and remove
19
2 counter clockwise to remove
with the side exhaust port
is aligned with the
14
14
13
To reduce the risk of
the battery pack before making any adjustments
or removing/installing attachments or
accessories. An accidental start-up can cause injury.

Lubrication

Never lubricate the vacuum motor. The motor bearings are
permanently sealed. This vacuum is intended for indoor
use and for wet or dry pick up, but it is not intended to be
exposed to rain.
Cleaning

WARNING:
air vents with clean, dry air at least once a week. To
minimize the risk of eye injury, always wear ANSI Z87.1
approved eye protection when performing this.

WARNING:
harsh chemicals for cleaning the non-metallic parts
of the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid get
inside the tool; never immerse any part of the tool into
a liquid.
Accessories

WARNING:
those offered by PORTER-CABLE, have not been tested with
this product, use of such accessories with this tool could
be hazardous. To reduce the risk of injury, only PORTER-
CABLE recommended accessories should be used with
this product.
A complete line of accessories is available from your
,
10
PORTER-CABLE Factory Service Center or a PORTER-CABLE
Authorized Warranty Service Center. Please visit our Web
Site www.portercable.com for a catalog or for the name of
your nearest supplier.
Repairs
The charger and battery pack are not serviceable.

WARNING:
SAFETY and RELIABILITY, repairs, maintenance
and adjustment (including brush inspection and
replacement, when applicable) should be performed
by a PORTER-CABLE factory service center or a
PORTER-CABLE authorized service center. Always use
identical replacement parts.
Register Online
Thank you for your purchase. Register your product now for:
• WARRAnTY sERViCE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with your product.
• COnFiRMATiOn OF OWnERshiP: In case of an
insurance loss, such as fire, flood or theft, your registration
of ownership will serve as your proof of purchase.
English
Blow dirt and dust out of all
Never use solvents or other
Since accessories, other than
To assure product
9