aircon Eco Power 9000 3in1 Manuel D'instructions page 38

HEATING IN INDOOR OPERATION
The unit is in the room to be heated.
Connect the air hose and the air outlet grid to the unit as displayed in the illustration; the air hose
connection piece and air outlet grid need to be exchanged.
The cold extract air has to be fed out of the room via the air hose. This can be executed e.g. via a tilted
window, a door or wall aperture. Make sure that no warm outside air can enter the room. For effective
heating, we recommend our selection of various accessories which reduce or prevent entry of cold air into
the room.
Set the function to "Heating". The settable temperature range is between 15 and 25 degrees target
temperature. You can set this using the temperature control.
After switching on, or over, the ventilator operates, but the compressor only starts after the control lamp has flashed for three minutes.
Cooling effect may require a further 10 minutes. Further information is available under the item, "Troubleshooting".
HEATING IN OUTDOOR OPERATION
The unit is outside the room tio be heated. Outdoor operation is ideal for the transition period in which
outside temperatures do no fall below 7 degrees.
(If the outside temperature should however fall below 7 degrees
Connect the air hose and the air outlet grid to the unit as
continuously, we recommend indoor operation).
displayed in the illustration, or the air hose connection piece and air outlet grid need to be exchanged.
Set the function to "Heating". The settable temperature range is between 15 and 25 degrees target
temperature. You can set this using the temperature control.
The air with high oxygen content heated by the unit is fed into the room via the air hose. This can be
executed e.g. via a tilted window, a door or wall aperture. Make sure that no warm outside air can enter the
room. For effective heating, we recommend our selection of various accessories which reduce or prevent
entry of warm air into the room.
Using the various "Comfort Control Kits" you can also control the unit from inside using the remote control.
After switching on, or over, the ventilator operates, but the compressor only starts after the control lamp has flashed for three minutes.
Cooling effect may require a further 10 minutes. Further information is available under the item, "Troubleshooting".
37