Installation; Installer / User Mode - Duco IQ-unit Guide Rapide

ENGLISH
6

Installation

6A.

Installer / User mode

To add, remove or replace components in the network, the system
must be set to 'Installer mode'. The LED on each component indicates
the active mode of the component (see table below).
'Installer mode' can be activated by pressing the IQ-unit 'INST' button.
Once the LED on the master unit starts flashing, it means that 'Installer
mode' is active. Press 'INST' again to return to 'User mode' (LED fully
on or off). The system reverts automatically to 'User mode' after 15
minutes of inactivity.
92