Installation; Pairing Components - Duco Actuatorprint Manuel D'utilisation

ENGLISH
4

Installation

4A.
Go through the following steps to pair components with the Duco
network.
Pairing as a supply component
Activate 'Installer mode' by tapping 'INST' on the master. The LED
1
will flash green rapidly.
Tap once on the Actuatorprint button while the User controller to
2
which it may require to be connected, rapidly flashes green. The
LED rapidly flashes red until the Actuatorprint has been added to
the network and will flash green.
Exit 'Installer mode' by tapping 'INST' on the master.
3
30

Pairing components