General Inspection; Lubrication - GMC LTP30 Traduction Des Instructions Originales

• Check the fuel filter periodically, according to the maintenance schedule. Do not allow dust to
enter the Fuel Tank. A clogged filter will make the engine more difficult to start and can cause
abnormalities in engine performance
• Replace the filter when dirty
• When the inside of the Fuel Tank is dirty, clean it by rinsing it out with petrol

General inspection

• Regularly check that all the fixing screws are tight
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and
GB
shorten the machine's service life. Clean the body of your machine with a soft brush, or dry
cloth. If available, use clean, dry, compressed air to blow through the ventilation holes
• Clean the tool casing with a soft damp cloth using a mild detergent. Do not use alcohol, petrol
or strong cleaning agents
• Never use caustic agents to clean plastic parts

Lubrication

• Slightly lubricate all moving parts at regular intervals with a suitable spray lubricant
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
• Always transport and store fuels in an approved container
• Mix only enough fuel for your immediate needs. If fuel must be stored longer than 30 days, it
should first be treated with a stabiliser or a similar product
Whenever storing for a long period of time, proceed as follows:
• Empty the Fuel Tank (21) completely
• Protect all metal engine parts from corrosion by coating them with oil
• Remove the spark plug, put a few drops of oil into the cylinder and then pull the Recoil Starter
(12) 2 to 3 times in order to distribute the oil evenly. Replace the spark plug
Disposal
Always adhere to national regulations when disposing of power tools that are no longer functional
and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE), with
household waste
• Contact your local waste disposal authority for information on the correct way to dispose of
power tools
12