Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
System Installation Guide
System installation at a glance
The equipment interface module (EIM) allows you to control a baseboard heater, a
convector or a fan-forced heater in a 120-volt, 208-volt or 240-volt application from a
EConnect™ wireless thermostat.
EIM in remote
junction box
Electrical
panel
Installation procedure
1
Install the equipment interface module (EIM).......................................Pages 3 - 6
2
Install batteries in wireless devices ............................................................. Page 7
3
Link all devices to wireless network ...................................................Pages 7 - 10
4
Exit wireless setup..................................................................................... Page 11
5
Customize thermostat (installer setup).............................................Pages 11 - 19
6
Mount thermostat and outdoor sensor .............................................Pages 20 - 21
For error codes, see page 21.
To verify the signal strength, see page 22.
To replace a wireless device, see pages 22-23.
For specifications and replacement parts, see page 24.
SAVE THESE INSTRUCTIONS
69-2474EFS—01
Thermostat
Heater
Supply wires
2
Thermostat
EIM in heater
Remote
control
Wireless connection
Outdoor
air sensor
Publicité
Table des Matières
