warmhaus Cleveland CMSF-1/0310 Mode D'emploi page 5

This fireplace can be operated with the switches located on the top panel of the fireplace.

Plug the fireplace into a power outlet.

Select the desired function:

Only Flame Effect On / Off ‐ (4)

Fan (No Heating) – (1)

Low Heat – (1 + 2)

High Heat – (1 + 2 +3)

Heat & Flame Effect – (1 + 2 + 3 + 4)

In order to activate the heat, it is necessary to turn on the fan. The fireplace will not emit heat
without the fan switch turned on.

Adjust the Flame Brightness Control knob for the desired flame effect. (5)

Adjust the Thermostat Control knob to regulate the heat.
Auto Safety Shut-Off Mechanism

This fireplace is equipped with a safety shut‐off feature which initiates if the fireplace overheats
(e.g. Due to blocked air vents). For safety reasons, the fireplace will NOT automatically reset,
and will need to be manually turned ON.

To restart the fireplace, unplug the fireplace from the power outlet for at least 15 minutes. Next,
reconnect to the power outlet and turn on the fireplace.
Troubleshooting
Unit does not work / does not heat
No flame effect
Replacing the Light Bulb
Problem Possible Solution
· Check if the unit is plugged in the power outlet.
· Check if the unit is in Standby mode. If so, turn
the unit ON.
· Check if the heat is turned OFF.
·
Check for safety cut‐off operation.
· Check if the unit is plugged in the power outlet.
· Check if the unit is in Standby mode. Turn the
unit ON.
5