Publicité
PART 4
INSTALLATION
Procedure (refer to Installation Diagram):
1.
Locate the studs in the area you want to mount your speakers.
2.
Use a level to ensure straightness.
3.
Trace the inside of your mounting template with a pencil.
4.
Carefully drill a 1" (2.5 cm) hole in the center of your traced cutout.
CAUTION:
ENSURE THAT EXISTING HOUSEHOLD CABLES,
PIPES AND DUCTS ARE NOT PRESENT IN THE WORKING
AREA.
5.
With a utility knife or keyhole saw, cutout the center area.
6.
Remove the center area using the 1" (2.5 cm) hole.
7.
Remove the speaker grille using a small flat-headed screwdriver to
pry it off.
8.
To ensure proper fit, temporarily place the speaker in the open
area.
9.
Repeat steps 1-8 for any additional speakers.
10.
Decide where your receiver will be placed.
NOTE: Each individual speaker wire will need to be routed to this
area.
11.
Drill a 1" (2.5 cm) hole in the wall where your receiver will be
located.
Wiring Your New Speakers (refer to Installation Diagram):
1.
Measure the distance from the nearest corner of the room to the
center of the cutout.
2.
Measure the distance from the nearest corner of the room to the
1" (2.5 cm) hole where your receiver is located.
3.
With these measurements and UL rated speaker wire go to the
attic.
4.
Locate the corner of the room where your measurement for Step 1
was taken from. Measure the exact distance in the correct direction
of your cutout and mark it with a pencil.
5.
Drill a 1" (2.5 cm) hole.
6.
Insert the wire through the hole and feed until the wire is visible
through the cutout.
7.
Leave about 2 feet (0.5 m) extending through the cutout.
PK-93026-10-02-0B-prnspread
6
5
PARTE 2
Pintado
Si para hacer juego con la decoración de su casa desea pintar la parte
visible del parlante. Primero use pintura Látex para pared o Pintura
Aerosol en Spray para pintar, luego cubra la rejilla del parlante con una
pintura anticorrosiva.
NOTA: Antes de pintar quite la tela dentro de la rejilla.
Direcciones:
1.
Quite cuidadosamente la rejilla del parlante. Afloje la rejilla con un
pequeño destornillador.
2.
Para pintar la cubierta del parlante, cubra la parte interior con la
plantilla que se incluye.
3.
Pinte.
4.
Después que la pintura esté seca totalmente, remueva
cuidadosamente la plantilla introduciendo un destornillador por la
ranura.
NOTA: No es necesario montar la rejilla en ese momento porque
necesitará tener acceso al interior de los parlantes durante la instalación.
9/25/03, 11:53 AM
20
Publicité
