Field Of Application; Adjustment - KONG Italy AMPERE Mode D'emploi

GB

Field of application

The resistance of the chip strap is between 15
and 25 daN (as required by EN 397 regulation).
Instructions for use
This product is part of personal safety
equipment. Read the above documentation
carefully before using the product. Be careful
to read and observe the following instructions
industrial use (EN 397) and it does not exempt
the user from personal liability for the related
risks. Activities carried out at heights
(either sports or industrial) involve serious
risks and danger for the head. Injuries cannot
be ruled out completely. In order to guarantee
the highest level of safety during such
activities, it is necessary to use equipment in
compliance with the current regulations and to
use it properly. The following instructions
for use are important in order to ensure
correct use. However, they cannot replace
experience, personal liability and awareness
of individual users concerning the risks related
to climbing, mountain climbing, working at
heights and industrial work, such instructions
do not exempt from personal liability due to the
related risks. Use is only permitted to trained
and skilled people or under the supervision
of an expert. The producer denies liability for
improper and/or incorrect use of the product.
Liability and risk rest entirely with the user. In
the case of use in rescue or PPE operations,
it is highly recommended to observe national
regulations on the matter.

Adjustment

In order to assure a safe protection, this
dimensions. The helmet must be adjusted to
side to side or move when the chin strap is
locked and the slider is in the correct position
based on the head perimeter. The helmet will
adjustment is done correctly. A perfect and safe
adjustment on the head is guaranteed only if
the chin strap is locked and tightened and with
a correct adjustment to the cranial perimeter.
The straps must not cover the ears and the
buckle must not touch the chin. The locked chin
strap must not exert pressure on the larynx. The
helmet must be adjusted on the head always
in a horizontal position so that it protects the
forehead as well.
1. wear the helmet with the back size adjust
system open
2. lock the size adjust system by rotating the
back wheel
3. lock the chin strap buckle. A locking "click"
must be heard. Tighten the strap so that the
buckle is properly locked
4. adjust the chin strap
5. check the correct position of the helmet and
the correct locking of the systems (buckle and
back size adjust system). If the helmet is worn
correctly, it must not move or rock side to side.
The better the helmet adjustment, the higher
the level of safety.
11