Fujitsu CG-311 Série Mode D'emploi page 5

9. Ventilation–The camera should never be
placed near or over a radiator or heat regis-
ter.
The camera should not be placed in a built-
in installation such as a bookcase or rack
unless proper ventilation is provided or your
appliance dealer's instructions have been
adhered to.
10.Power Sources–The camera should be op-
erated only from the type of power source
indicated on the rating plate. If you are not
sure of the type of power supply to your in-
stallation site, consult your appliance dealer
or local power company. For cameras in-
tended to operate from battery power, or
other sources, refer to the operating instruc-
tions.
11.Power-Cord Protection–Power-supply cords
should be routed so that they are not likely
to be walked on or pinched by items placed
upon or against them, paying particular at-
tention to cords at plugs, convenience re-
ceptacles, and the point where they exit from
the camera.
12.Lightning–For added protection for the cam-
era during a lightning storm, or when it is
left unattended and unused for long peri-
ods of time, unplug it from the wall outlet
and disconnect the cable system. This will
prevent damage to the camera due to light-
ning and power-line surges.
13.Overloading–Do not overload wall outlet
and extension cord, as this can result in a
risk of fire or electric shock.
14.Object and Liquid Entry–Never push objects
of any kind into the camera through open-
ings, as they may touch dangerous voltage
points or short-out parts that could result in
a fire or electric shock. Never spill liquid of
any kind on the camera.
15.Servicing–Do not attempt to service the
camera yourself as opening or removing
covers may expose you to dangerous volt-
age or other hazards.
Refer all servicing to qualified service per-
sonnel.
En-3