Programming Codes; Alarm Handling; Technical Specifications - Perel Tools 6000-30 Mode D'emploi

Note: to hide codes when opening the safe, press the START button [C] twice at the
beginning of the procedure.

Programming codes

Note: for security reasons it is strongly advised to reprogram the user and master code
immediately.
User code:
o Open the safe and press the SET button [H] once. The display shows "SET CodE".
o Enter a new user code consisting of 3 to 8 numbers. Press the START button [C] to
confirm; the display will show "IN".
Master code:
o Open the safe and press the SET button [H] once. Press the START button [C]. The
display shows "oLd CodE".
o Enter the original master code (factory preset = 8888) and press the START button
[C]. The display shows "SET".
o Enter a new master code consisting of 3 to 8 numbers. Press the START button [C] to
confirm; the display will show "rE-InPUT".
o Enter the same new master code again and press the START button [C] to confirm; the
display will show "IN".

Alarm handling

• When a wrong code is entered, the red LED [G] lights up while the display shows "Error".
The safe will not open.
• After consecutively entering 4 wrong codes, the buzzer [B] will sound for ±3 minutes.
During this time it is not possible to enter any codes.
• It is always possible to use the override key to open the safe (see §3: Opening the safe
for the first time). The buzzer [B] can then be reset by pressing the SET button [H].
Mounting the safe
• T0 reduce risk of theft, the safe should be secured to floor and wall using the pre-drilled
holes.
• There are 8 mounting holes (Ø8mm), 4 in the back plate and 4 in the bottom of the safe.
Use the included screws to secure the safe.
CAUTION: the safe is heavy and should therefore only be mounted on a solid surface or
wall that is strong enough to hold its weight.

Technical specifications

4.
power supply
dimensions (L x W x H)
Use this device with original accessories only. Velleman nv cannot be held
responsible in the event of damage or injury resulted from (incorrect) use of this
device.
For more info concerning this product, please visit our website www.perel.eu.
The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
This manual is copyrighted. The copyright to this manual is owned by Velleman Components nv. All worldwide
rights reserved. No part of this manual may be copied, reproduced, translated or reduced to any electronic medium or
otherwise without the prior written consent of the copyright holder.
08/04/2009
6000-30
4 x 1.5V AA batteries (incl.)
350 x 250 x 250mm
4
©2008 Velleman ® Components nv