POLTI FORZASPIRA C130 Plus Manuel D'instructions page 21

the two reference arrows (12-13).
- Remove the container sponge
- Unscrew the lower part of the filter unit but
turning it clockwise, relative to the upper part
(14-15).
- Rinse all the components under running wa-
ter and let them dry.
- Replace everything repeating the steps de-
scribed previously in the reverse order.
ATTENTION: Check all components of the du-
st collector are dry, before put them in order.
We recommend to clean the container after
each use.
8.2 REMOVING AND CLEANING THE HEPA
FILTER
- Turn the grill clockwise (16) and remove the
filter (17).
- Rinse the HEPA filter using running water
only and shake gently to remove any excess
dirt or water residue; before replacing the filter
in the appliance, leave to dry naturally away
from direct light and heat for at least 24 hours.
The filters should be fully cleaned approxima-
tely twice per year.
WARNING: Check the filters during cleaning.
Replace the filters when visibly damaged.
WARNING: Do not clean the filters with the
brush as they can be damaged, reducing
their filtering capacity. Do not use deter-
gents, do not rub the filter, and do not wash
it in a dishwasher.
9. CLEANING THE MINI TURBO-
BRUSH
9.1 Turn and pull the locknut outwards (18).
9.2 Open the upper part and clean the inside
of the brush (19).
9.3 Close the brush following the procedure in
reverse order.
10. STORAGE
10.1 Turn off the appliance and disconnect
from the mains electricity.
10.2 Press the cable-winder button
activate the automatic winding guiding it
gently back into the appliance.
10.3 The hose and flexible hose can be housed
on the body of the appliance, sliding the uni-
versal brush into the parking system on the
appliance (20).
10.4 The small nozzle and the lance can be at-
tached to the telescopic tube using the acces-
sory holder. Attach the single ring to the tele-
scopic tube and insert the accessories in the 2
other rings (21).
(5) to
| 21 |