Other Functions; Storage And Maintenance - AKASO G101 Mode D'emploi

Other Functions

Restore factory settings:
Press and hold the left and right buttons for 3 seconds, the red light will flash for 3
consecutive times, indicating that the factory settings are restored.
Disconnected and reconnect:
The headset is disconnected from the smart phone, and there are two "beep" tones. At this
time, press the key to reconnected.
On the phone, accompanied by the "Connected" tone.
Low battery voltage:
The red light is always on and accompanied by a "beep" tone.

Storage and Maintenance

1. Store your headphones in a cool, dry place. Operating temperature 0~45°C(32-113°F).
Working in a cold/hot loop mirror or in a highly humid place can reduce battery life.
After storing for a long time, please charge it before use.
2. This BT headset is water resistant, but not completely waterproof. It can't be placed in water
for a long time and cannot be used for diving. If there is water, wipe it off with a clean soft
cloth.
3. Clean the headphones with a soft, dry cloth.
4. Do not touch any sharp objects to the headphones.
5. Do not place the headphones under a very high or low temperature ring mirror.
Common Problems and Their Solutions
Problem
Cause of
Description
Battery is exhausted
Not booting
Long press the power button for too short
Not charging Charging plug is not plugged in
Misoperation caused the headset
Not booting
program to go wrong
The headset does not enter the
Unable to search
pairing state
or pair failed
Mobile phone BT application error
User Manual
Scan the following QR Code or enter to the website to
download detailed user manual.
www.akasotech.com/usermanual/g101.pdf
Contact Us
For any inquires, issue or comments concerning our products, please send E-mail to the
address below, and we will respond as soon as possible.
E-mail: cs@akasotech.com
Tel: (888) 466-9222 (US) Mon-Fri 9am-5pm (EST)
Brand web: www.akasotech.com
Problem Solving
Fully charge with the charger
Reboot the button
Reinsert the charging plug
Change reset with the charger
Put the headset into the
pairing state
Turn off the phone and reboot