XYZprinting Da Vinci Nano Guide Rapide page 5

Printer Setup
Installing the Filament
Lower the filament spool
01
holder on the back side of
the printer until horizontal.
Replace the New Filament Spool
Use a Phillips head
01
screwdriver to loosen the
securing screws of the
filament spool ring.
Install the sensor chip.
04
Note the orientation of the
sensor chip on the spool
ring.
Place the assembled
02
filament spool (with the
spool ring) on the spool
holder.
*If you have just unboxed the da Vinci nano, the sensor chip should
already be loaded.
Separate the spool ring
02
from both sides of the
spool.
Feed both parts of the
05
spool ring through the
center hole of the spool
and assemble them
together.
Note
• The filament will load better
when the tip of the filament
is cut at a 45° angle.
• When the printer is not in
use, raise the filament spool.
Take out the filament spool
03
and the sensor chip.
Use a Phillips head
06
screwdriver to tighten and
secure the spool ring to
complete the installation.
5