Primo EuroSpa Mode D'emploi page 4

English Instructions
IMPORTANT: Read these instructions carefully and retain them for
future reference.
IMPORTANT: Primo reserves the right to modify the product for technical or commercial
reasons without prior notice.
IMPORTANT: This product must be used for the purpose that it was designed for; any
misuse releases PRIMO from any and all responsibilities. Never use replacement
parts other than th ose supplied by the PRIMO.
IMPORTANT: Never leave your child unattended!
1. Firmly push the 4 lower tubes through the holes in the front and rear wheels,
as shown in fig.1 & 2.
2. Attach the two (2) handles and then the two (2) bath support tubes as shown in
fig.3. Line up all 3 holes and screw together using 1 "X" type screw on each leg.
3. Assemble the lower shelf as shown in fig.4. Make sure that you first lock
the bigger slot (PART "F") and then the smaller one (PART "G"). You
will hear the shelf snap into pla ce.
4. Assemble the higher shelf as shown in fig.5. Make sure that you first lock
the bigger slot (PART "H") and then the smaller one (PART "I").
5. Put the bath on the frame and push until you hear a "click" on the bath support
tubes (fig.6). Insert the drainage tube to the underside of the bath as shown in
fig.7.
6. Screw the hinges on the back of the changing top with the 4 " Z" type screws
as shown in fig.8. You can feel the pre-drilled screw holes under the fabric.
7. Fit the changing top with the hinges assemble d onto the bath and then screw the
fixed part of the hinges through the frame, using 4 "X" type screws (f ig.9) .
8. Fit the accessory trays on the 2 shelves as shown in fig.10; slide them to the
desired position.
9. To close changing pad, lift up and the locking mechanism will
EuroSpa™ Part # 350-090110)
(PRIMO
®
4
release.