Technical Specifications; Battery Charging Instructions - Sunoptic Surgical SSL-3736-2 Manuel Opérateur

3.

TECHNICAL SPECIFICATIONS

Input
Output
Operating Temperature
Storage Temperature
Humidity
Dimension (without power supply)
Weight (without power supply)
Water Resistant
Regulatory approvals
Electromagnetic Emissions
ESD immunity
Electromagnetic field immunity
EFT / Burst
Surge
Conducted Immunity
Magnetic Fields
Voltage dips, short interruptions, and
voltage variations
Immunity characteristics

4. BATTERY CHARGING INSTRUCTIONS

Place the charger on a stable surface. Plug the output connector of the external AC/DC power
supply into the DC input located on the rear of the charging station. Then plug the external
AC/DC power supply into an AC outlet.
If desired, route the AC/DC cable under the cable retention clip located on the rear of the charger,
and press down on the clip until it clicks. To release the cable retention clip, slide the clip laterally
until it clears the hook
LIT-232 Sunoptic Surgical
Rev. B
Item
Item
.
®
Page 5 of 48
Specification
19 - 26VDC 3.4A max
0 – 17.4V 4.8A max
0⁰C to 40⁰C (32⁰F to 104⁰F)
-10⁰C to 70⁰C (14⁰F to 158⁰F)
5% to 95% r.H. non-condensing
(LxWxH) 155 x 175 x 43 mm
325g
Not Protected Equipment, IPX0
Specification
CE, CB
EN55011, EN55032, level B
FCC15 class B
EN/IEC61000-4-2
EN/IEC61000-4-3
EN/IEC61000-4-4
EN/IEC61000-4-5
EN/IEC61000-4-6
EN/IEC61000-4-8
EN/IEC61000-4-11
EN55024
(English)