Winter Storage - Outside Living Industries INFINITE spa CHAMPION Mode D'emploi

4
Maintenance
4.5 Cleaning the SPA
The cleaning of the SPA does not require any special care or maintenance. Remove dirt with soap. water, a damp cloth and a soft brush, if
required. Never use hard brushes or abrasive cleaning and scouring products.
4.6 Repair
If the PVC wall of the SPA has small holes or punctures these can be securely and invisibly repaired with the repair patches supplied with the
SPA.
- Spray some soapy water on the suspicious spot. Bubbles will form if a tear or puncture is present.
- Thoroughly clean and dry the area to be repaired.
- Spread the adhesive evenly over the back of the repair patch and press the patch over the damaged area.
- Smooth the surface to remove any air bubbles.
- Leave the repaired area to dry for 12 hours before using the SPA again.

4.7 Winter storage

1. Drain all the water from the SPA.
2. Remove the filter cartridge
3. Clean and dry the SPA and attachments
4. Expel all the air from the SPA
5. Loosely fold up the SPA, avoiding sharp corners to prevent damage
6. Store the SPA in a dry, frost-free place.
8. The original packaging can be used for storage.
CAUTION:
• Plastic can become brittle and fragile when it is exposed to sub-zero temperatures.
• Freezing can severely damage the SPA. Improper winter storage may invalidate the warranty.
• Ubbink Garden B.V. cannot accept liability for damage to the SPA and its components resulting from the use of antifreeze agents.
5
Troubleshooting
Here you will find useful tips to help you identify and remedy some of the most frequent faults.
Problem
The jet system is not
working
The massage jet system is
not working
Heater
not working
Filter system
not working
Manual SPA 2/4/6 2019 3.indd 42 Manual SPA 2/4/6 2019 3.indd 42
Cause
Overheating of the air fan motor
Problem with the filter/air and massage jets/heater
unit
Overheating of the massage jet motor.
Problem with the filter/air and massage jets/heater
unit
Temperature set too low
The water temperature is still within the tolerance
range of the temperature sensor (+/- 2°C)
The filter cartridge is dirty
Water level too low
Problem with the filter/air and massage jets/heater
unit
The filter cartridge is dirty
Problem with the filter/air and massage jets/heater
unit
Solution
Wait until the motor has cooled down, then press the BUBBLE button to activate
the function.
Disconnect the power supply, wait 10 minutes before switching the power
back on.
Call our customer service department if the jet function cannot be reactivated
Wait until the motor has cooled down, then press the JET button to activate the
function.
Disconnect the power supply, wait 10 minutes before switching the power
back on
Call our customer service department if the jet function cannot be reactivated
Set a higher temperature (20-40°C)
The heating system does not switch on immediately, but after a delay.
Replace the filter cartridge
Top up the water
Disconnect the power supply, wait 10 minutes before switching the power
back on
Call our customer service department if the heater function cannot be
reactivated
Replace the filter cartridge
Disconnect the power supply, wait 10 minutes before switching the power
back on
Call our customer service department if the filter function cannot be reacti-
vated
19.11.19 11:55 19.11.19 11:55