SEVERIN 8410.0000 Mode D'emploi page 9

No responsibility is accepted if damage
results from improper use, or if these
instructions are not complied with.
In order to comply with safety regulations
and to avoid hazards, repairs of electrical
appliances must be carried out by qualifi ed
personnel, including the replacement
of the power cord. If repairs are needed,
please send the appliance to one of our
customer service
address can be found in the appendix to
this manual.
General information
A foot massage helps to reduce tension in
muscle and tissue areas, enhancing the blood
circulation and simultaneously stimulating
the metabolic process, thus cleansing the
body tissue of waste residues.
– A roller-massage
designed for massaging the refl ex zones of
the feet, is located between the foot pads
and can be removed for cleaning.
– In order to enhance the massage eff ect,
a foot massage should be applied using
warm water. A non-foaming bath gel may
be added.
– Th e integral heating element located
underneath the studded foot pads
prevents the warm water from cooling
down too fast, although it is not designed
to heat up the water.
Th e user is recommended to refrain from
massage treatment when suff ering from
phlebitis in the legs, varicose veins (if they
tend to bleed easily), skin rash, infl amed
or swollen feet or any pain of unknown
origin. If in doubt, consult your doctor
before using the appliance.
departments. Th e
unit, specifi cally
Control settings
0 Unit is switched off
Massage
Heating + bubble function
Heating + bubble function +
massage
Operation time-limit
Th is foot massager is designed to be operated
for a maximum of 20 minutes at a time
without interruption, aft er which it must
be switched off and allowed to cool down
suffi ciently before being switched on again.
Operation
– Place the foot massager on the fl oor in
front of a chair.
– If required, the roller massage insert can
be fi tted.
– Fill with warm water until the indicated
water level is reached.
– Insert the plug into the wall socket. Make
sure that the control switch is in the "0"
position.
– Seat yourself comfortably on the chair and
position your feet on the foot pads. Do
not stand on the unit.
– Select the desired function with the control
switch. Th e recommended application
time is 10 to 20 minutes.
– Aft er use, set the control switch to "
again before removing the plug from the
wall socket.
– Empty out the water aft erwards.
Cleaning and care
Before cleaning the appliance, ensure it is
disconnected from the power supply.
To avoid the risk of electric shock, do not
clean the housing of the foot massager with
water and do not immerse it in water.
Do not use abrasives or harsh cleaning
9
0"