Utilitech Pro SE1048-BP2-02LF0-U Manuel page 9

TROUBLESHOOTING
PROBLEM
Security light comes
on during the day.
Security light cycles ON
and OFF continuously.
Security light comes
on for no apparent
reason at night.
WARRANTY
commercial or retail application. The warranty is limited to use in a residential environment. We will repair or
replace (at our option) the unit in the original color and style if available, or in a similar color and style if the original
item has been discontinued, without charge. Defective units must be properly packed and returned to the
manufacturer with a letter of explanation and your original purchase receipt showing date of purchase.
Call 1-866-994-4148 to obtain a return authorization number and an address where to ship your defective product.
Note: C.O.D. shipments will NOT be accepted. The liability of the manufacturer is in any case limited to
labor costs or injury which is caused by the product. This limitation upon the liability of the manufacturer includes
any loss, damage, labor costs or injury which is (I) to person or property or otherwise; (II) incidental or
consequential in nature; (III) based upon theories of warranty, contract, negligence, strict liability, tort, or otherwise;
and you may also have other rights which vary from state to state.
POSSIBLE CAUSE
1. Dusk-to-Dawn sensor is
a shaded area and is
fooled into thinking it
is nighttime.
2. Dusk-to-Dawn sensor
is faulty.
1. Dusk-to-Dawn sensor is
from the security light.
1. Light is sensing motion
in the detection zone.
CORRECTIVE ACTION
mounted in an area that does not allow enough
light to enter the sensor. Relocate security light.
2. If under warranty, contact Customer Service.
1. Change the position of the light head, aim light
2. Put a small piece of black electrical tape over
the Dusk-to-dawn sensor.
3. Relocate the security light to a different location
1. Make sure the sensor is not picking up moving
2. Test the motion sensor by covering up the front
curved lens with cardboard to block the view. If
the light turns off then something in the
detection zone is triggering the sensor.
Reposition the motion sensor or change the
sensitivity (distance) of the sensor.
Utilitech & UT Design® are registered
trademarks of LF, LLC. All Rights Reserved.
9
A
Printed in China
Lowes.com