James EJ 100 S Mode D'emploi page 14

EN
Dear Customer,
To guarantee the safety and correct working
of the appliance, please read the following
instructions CAREFULLY before beginning the
installation.
IMPORTANT:
Make sure that the power supply has been dis-
connected before performing the installation or
electrical connection of the appliance. "
Installation, electrical connections and settings
must be carried out by a qualified person in line
with local regulations.
If these installation instructions are not fo-
llowed the product may be damaged.
For optimal performance, the appliance must
be installed correctly (installation of the unit,
ducts and air replacement inlets).
This extractor fan is designed for the ventilation
of households or similar premises. Do not use
for any purpose other than that for which it was
designed.
This appliance can be used by children aged
from 8 years and above and persons with redu-
ced physical, sensory or mental capabilities or
lack of experience and knowledge if they have
been given supervision or instruction concer-
ning use of the appliance in a safe way and un-
derstand the hazards involved. Children shall
not play with the appliance. Cleaning and user
maintenance shall not be made by children
without supervision.
The fan is to be installed so that the blades are
more than 2,3 m above the floor.
This extractor fan does not produce radio/tele-
vision interference (Directive 2014/30/EU).
Prior to piping installation, consult the munici-
pal by-laws on air outlets and request permis-
sion from the person responsible for the buil-
ding.
Precaution must be taken to avoid the backflow
of gases into the room from the open gas pipe
or from other open-flame devices.
The room must have adequate ventilation if this
appliance is used simultaneously with other
appliances that run on gas or other fuels.
Do not install the exhaust conduit (D) of the
extractor fan to a chimney flume, ventilation
pipes, hot air ducts or ducts used to evacuate
fumes from appliances that run on gas or other
fuels.
DO NOT install this product in areas with the
follow characteristics:
• Excess of oil or grease.
• Areas with corrosive, explosive or flammable
liquids, gases or vapours.
• Areas with temperatures higher than 40 °C or
lower than -5 °C.
• Areas exposed to the environment (rain, sun,
snow, etc.)