Eurotops YT6601-02 Manuel De L'utilisateur page 39

Replacing the scraper (Fig. 13)
The scraper is located at the base of the snow thrower beneath the rotor
housing.
- Remove the screws that secure the scraper to the snow thrower.
- Install the new scraper and fasten it securely with the screws.
Replacing the auger belt
Under normal operating conditions it should not be necessary to replace the
auger belt. However, should the auger jam or malfunction the belt could be
damaged. To replace the belt follow these instructions.
Belt drive system structure (Fig.14)
1. Open the left side plate by the removing 3screws (Fig. 15)
38
GB