Maintenance; Emptying The Dust Collector - Inventum DE010 Mode D'emploi

6

maintenance

Check the dust collector and filters regularly to prevent any problems. Empty the dust collector when it is full and clean or replace
the filters when they are dirty.

EMPTYING THE DUST COLLECTOR

Empty the dust collector after every use. First remove all accessories before emptying the dust collector.
• Hold the dust collector above a dust bin and unlock the lid with the clip.
• To fully empty the dust collector, calmly shake it above the dust bin and close the lid.
CLEANING THE CYCLONE SYSTEM AND THE FILTERS
First remove all accessories before cleaning the vacuum cleaner. Clean the filters and the cyclone system
once every four times you have emptied the dust collector.
• Press the button to release the dust collector and remove it by turning it clockwise.
• Remove the cyclone system by turning it clockwise.
• The separate parts can be cleaned under lukewarm water.
• Press the relese buuton on top of the vacuum cleaner to remove the lid of the HEPA filter compartment.
• Take out the HEPA filter and clean it under lukewarm water and let it air dry. Do not use any cleaning agents
or brushes. Cleaning the filter will remove the dirt, but will not restore the original color of the filter. The
color of the filter is not of any influence to the performance.
• Re-assemble the vacuum cleaner in reverse order when all the parts are thoroughly dry. You will hear a click
when the dust collector is placed correctly.
Attention
• Use the vacuum cleaner only when the filters are in place. If not, it can lead to loss of suction power or damage to the motor.
• Torn filters or filters that do not fit properly can cause damage to the engine. Replace a damaged filter by an original new one.
CLEANING THE TURBO BRUSH
Hair and /or other dirt can be stuck in the brush of the turbo brush. Therefore clean the turbo brush regularly to ensure effinciency
of the vacuum cleaner.
• Make sure the vacuum cleaner is switched off and and disconnect the turbo brush.
• Unlock the tab at the bottom of the turbo brush with a coin or flat screwdriver and flip it upwards.
• Carefully pull out the brush.
• Clean the brush under lukewarm water and let the brush air dry.
• Place the brush back in the turbo brush.
• Close the tab and lock it with a coin or flat screwdriver.
20
• English