Algam Lighting PHEBUS Manuel D'utilisation page 18

MENU OPERATING INSTRUCTION
Once after every power on laser, the VERSION and MANUFACTURE INFORMATION will be shown in
LCD monitor of rear panel. When laser is powered on, LCD monitor on rear panel shows the current
operating standalone mode or DMX address of DMX mode. With help of LCD control panel, is very easy to
set and change the operating mode of laser. After every resetting and saved, the new mode information will
be shown on LCD monitor at next power on.
FUNC Mode Option, to choose the operating mode of laser.
ENTER
Confirmation, to confirm the laser to show the present mode at the next operation.
UP
DOWN UP/DOWN, to change operating mode, parameter or DMX address.
UP/DOWM
UP/DOWM
UP/DOWM
UP/DOWM
UP/DOWM
UP/DOWM
UP/DOWM
UP/DOWM
UP/DOWM
UP/DOWM
UP/DOWM
UP/DOWM
UP/DOWM
Note: In sound model, device will
close light in 5 seconds automatically,
if there isn't any sound signal. Light on
until sound signal recived.
UP/DOWM