Technical Data - ECG VT 3220 2in1 Mode D'emploi

2. Holding the vacuum cleaner body, align the mark on the dust container with the locking mechanism and
turn the container towards the mark clockwise.
3. Insert the dust container by inserting the positioning hook into the hole at the bottom and turn it. A proper
insertion in place will be accompanied by an audible click.
Positioning
hook
Cleaning the vacuum cleaner
Make sure before cleaning that the vacuum cleaner is not connected to the charger.
Use soft and slightly moist cloth with a few drops of detergent to clean the vacuum cleaner. Never use solvents
or other abrasive cleaners.
Never immerse the vacuum cleaner or the adapter in water or any other liquid and do not place it under
running water.
TROUBLESHOOTING
Problem
The handheld vacuum
cleaner does not work
The motorized brush of the
floor vacuum cleaner does
not work.
The handheld vacuum
cleaner does not collect dirt
or has weak suction power.
Dust escapes from the
handheld vacuum cleaner.
The battery does not hold
the charge.

TECHNICAL DATA

Wireless vacuum cleaner
Washable filter
Charging time: appr. 4.5 hours
Hole in the vacuum
cleaner body
Cause
• The battery is empty.
• Faulty battery (does not hold the charge).
• Dirty contacts between the appliance and
the charging contacts.
• Charging adapter is connected to an outlet
without voltage.
• The charger is connected.
• The blade fan wheel is clogged with dirt.
• Broken belt.
• The handheld vacuum cleaner is not properly
inserted.
• Dust container is full.
• You must clean or replace the dust container
filter.
• The vacuum cleaner battery is empty.
• Dust container is full.
• Incorrectly installed dust filter.
• Torn dust filter.
The battery is dead.
Correction
• Charge the appliance.
• The battery is dead.
• Clean the contacts.
• Check the fuses, use different outlet.
• Disconnect the charger.
• Remove dirt from the blade wheel.
Cu tangled hair, etc. carefully with
scissors.
• Call service.
• Insert the handheld vacuum properly.
• Empty the dust container.
• Remove the filter and make sure the
suction hole is not clogged. Clean or
replace filter.
• Charge the vacuum cleaner.
• Empty the dust container.
• Check proper insertion of the dust
filter.
• Replace the dust filter.
Call service.
Operating time: about 20 minutes
Dust container capacity: 1 l
Charging battery indicator
9