How To Operate - Igloo IRF32BK Manuel D'utilisation

HOW TO OPERATE

Before first use, remove all adhesive tape from the drawers, shelves, and trays.
INSTALLATION
1. The refrigerator should be placed on a completely flat surface. Allow 1 foot of space
on each side of the refrigerator and between the refrigerator and the wall. Also allow
at least 8 inches of space between the top of the refrigerator and the ceiling.
2. Choose a location for your refrigerator that is not exposed to sunlight, high
temperature or humidity, as humidity may stain and damage the refrigerator.
3. The appliance can be adjusted by rolling the two legs in the bottom front of the refrigerator
if it becomes unstable. Raise the refrigerator by rolling the two legs clockwise.
4. The surface of the location where the refrigerator is installed should be firm and
flat. If refrigerator is not secured in a proper location, noise and vibration may
occur. The noise may be increased if the floor is not firm. If you have to position the
refrigerator on a carpeted floor, place a sheet underneath the refrigerator, such as
plywood or a plastic mat, to prevent heat emissions from ruining the carpet.
5. Make sure that legs are pressed firmly into the floor and allow the refrigerator
to lean backward slightly so that the doors remain closed.
PLACEMENT OF FOOD
1. There should always be some space between items inside for air circulation.
2. Food should be kept in sealed containers to avoid becoming
dry, spoiled or creating odors in the refrigerator.
3. Hot food should be cooled down before placing into the
appliance. Otherwise, bacteria will grow in food.
4. Reducing the frequency of opening the doors can lower the electronic consumption.
NOTE: Do not use any electronic equipment inside the appliance.
ADJUSTING TEMPERATURE
The temperature of the refrigerator can be controlled manually by the knob.
However, the number shown on the knob does not correlate to the degrees. The
higher the number, the lower the interior temperature of the refrigerator will be.
0 = OFF
2-4 = Normal Use
DEFROSTING
Heavy frost will effect the efficiency and performance of the refrigerator and can
create increased energy consumption. If the frost inside of the freezer gets as thick as
¼ inch, you must defrost the refrigerator. Follow these steps to defrost the freezer:
1. Remove all food from the refrigerator and freezer.
2. Uninstall the drawers and shelves.
3. Unplug the power supply cord.
4. Open the doors and wait for the appliance to thaw completely.
1 = Higher (warmer) Temperature
5 = Lower (colder) Temperature
8